1 / 8
FMS PA-18 1700MM - Walksnail Moonlight GM3 - FPV mod — image 1
1 / 8

FMS PA-18 1700MM - Walksnail Moonlight GM3 - FPV mod

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Turn your FMS PA-18 into an FPV aircraft using the Walksnail Moonlight digital vision system in combination with the GM3

Rating
0 / 5
Likes
0
Downloads
4
Makes
0
Views
47
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

I decided to use a 4-pin magnetic connector: the power pins and the 2 UART pins used for communication between the FC and the VTX. That's all needed.

From the Walksnail system, I used the Moonlight camera KIT and the GM3 gimbal (I’m using the older v1 version; I haven’t checked compatibility with v2, but if the mounting leg spacing is the same, it should work)

Assembly instructions:

- Glue the magnetic connectors to the 3D-printed parts, I used a 2-component epoxy
- Glue the cabin_mount to the fuselage—I used epoxy again, but I think UHU Por would work too
- Mount the gimbal, camera, and VTX on the “cabin” part, solder the camera and VTX power lines together and route them to the connector; do the same for the UART from the VTX; the rest of the connections are between the gimbal, camera, and VTX
- I also secured any loose wires with B-7000 adhesive so they wouldn’t dangle and cause additional vibrations
- Solder the wires from the connector in the fuselage in line with the rest of your connections



Connector:

https://aliexpress.com/item/1005006525401310.html

I used variant: "4P - No ears MG0P254B Male Feamle with 150mm Open wire"


Airplane:

https://aliexpress.com/item/1005004086841313.html

Fit test:

Some flight tests:



Check out also pitot mount for this plane:

Tags