ESP32-S3 DevKitC-1 Case - Slim Snap-Fit Enclosure for S3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for ESP32-S3 DevKitC-1. Slim, snap-fit, ventilated, USB-C access, no supports.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 20
- Makes
- 0
- Views
- 137
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
Enclosure for the ESP32-S3 DevKitC-1 - the long, narrow S3 board.
From my Maker Enclosure Collection. Slim design that protects your S3 project while keeping it pocket-sized. Does not block WiFi signal.
Features:
- Designed for ESP32-S3 DevKitC-
- Internal slide rails - board locks without screws
- Snap-fit lid with secure clips
- Full ventilation on sides and top
- Precise cutout for USB-C port (S3 native)
- Ultra-slim 2-part design, fast print
Material: PLA or PETG
- Layer height: 0.2mm
- Walls: 3 perimeters
- Infill: 15-20%
- Supports: NO
- Orientation: Flat side down as shown
Tip: PETG gives better flex for snap clips.
Part of The Maker Enclosure Collection - check my profile for Arduino, ESP32, FPGA cases.