Gridfinity box for M5Stack Core S3 SE
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.06 – €2.52 net (excluding VAT)
For file: M5Stack C3-SE gridfinity 45deg_0.4n_0.2mm_PETG_COREONEL_1h58m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.29 excluding VAT (range midpoint).
- Weight reported by the author
- 38 g
- Print time reported by the author
- 1.97 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Gridfinity box for M5Stack Core S3 SE, 2x2
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 51
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About
I got a M5Stack Core S3 SE as a present and I decided to get a better stand for it.
Extra holes on the bottom 6mm diameter to allow putting the screws and screwing them in.
Photos from Sunlu PETG Coffee Brown that was pretty wet and printed very quickly, so it ends badly :D
Two options:
- full flat
- 45 degrees angled and slightly pushed to the back to allow extra stacks.
Magnets 6x2mm.
Screws M3, you need to chose one which are long enough to your stack.
Please like, create makes and add comments also to the original model, thanks!
Changelog
2026.10.12 - initial release
provided gcode is just for time and material estimations
0.2mm PETG 0.4 nozzle, stock profile, supports on the base plate only to avoid ugly artifacts in the thumbscrew areas
no brim, no supports, no skirt
Assembly
print
add M3 screws, watch out for the different lengths