1 / 2
Fascia Pixel Clip for 12 mm Bullet Pixels — image 1
1 / 2

Fascia Pixel Clip for 12 mm Bullet Pixels

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A screw-in clip that holds one 12mm bullet pixel under the bottom edge of a fascia board.

Rating
0 / 5
Likes
1
Downloads
6
Makes
0
Views
40
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

What it is

This clip holds one 12mm bullet pixel under the bottom edge of a fascia board. A fascia board is the vertical trim board along the edge of the roof. You use one clip for each pixel on the string.

The clip has a tab and a plate. The tab sits flat against the underside of the fascia. One countersunk #6 wood screw goes up through the tab into the wood. The plate hangs 16 mm below the fascia, flush with the front face of the board. The pixel pushes into the hole in the plate and points out toward the street.

Pixel fit

The clip fits 12mm bullet pixels with snap barbs, for example the ALITOVE WS2811 12V strings. The model uses these pixel dimensions:

  • Body diameter: 12mm

  • Flange diameter: 13mm

  • Maximum panel thickness for the barbs: 2 mm


The plate is 3.2 mm thick. A recess in the back of the plate makes the area around the hole 1.9 mm thick. The barbs open into this recess and lock the pixel in the plate.

Print settings

Material: ASA. If the clips are in full shade, PETG is also acceptable. Do not use PLA, because it gets soft in summer heat.

Orientation: LED hole down

Supports: None

Layer height: 0.2 mm

Bed Adhesive: Glue recommended due to small footprint and the corners can start to lift

Tags