RCWL-1670 Water Level Sensor Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.57 – €0.70 net (excluding VAT)
For file: RCWL-1670-Parametric-Enclosure-v15-Sensor-Lid-1-Sensor-Lid-MK3S.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.64 excluding VAT (range midpoint).
- Weight reported by the author
- 10 g
- Print time reported by the author
- 34.2 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Roof-mountable RCWL-1670 sensor enclosure with a removable lid, TPU gasket and M12 cable gland.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 14
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Roof-mountable RCWL-1670 ultrasonic sensor enclosure with a removable lid, TPU perimeter gasket and M12 cable gland.
The base stays mounted beneath a roof or frame while the lid and sensor are removed downward. The main body is 70 × 44 × 22 mm, with an approximately 90 × 70 mm footprint including the mounting tabs. A recessed 2 mm thick TPU gasket seals against a continuous lid lip; the rigid mating faces limit nominal compression to 0.2 mm.
Three printable parts are supplied: base, sensor lid and TPU gasket. Screws, heat-set inserts, the RCWL-1670 sensor and M12 gland are purchased parts. Their individual reference STLs are deliberately excluded. The assembly STL is for reference only; use the separate component STLs for printing. Editable Fusion F3D and assembly STEP sources are included.
Assembly
Fit five M2 3×3.2 mm heat-set inserts to the sensor lid and four M3 5×5 mm inserts to the external base lugs. Check insert fit on your printed parts before heating them into place. Retain the sensor’s original rubber seals around the transducers and secure its PCB to the five lid posts using five M2×4 screws.
Fit a purchased M12 cable gland to the side opening, retaining its supplied sealing washer and locknut. Route the cable with sufficient slack to remove the lid downward. Seat the printed TPU gasket in the base groove, engage the lid’s continuous lip and close evenly with four M3×8 screws. Mount the external slotted tabs using suitable M4 fasteners for your installation.
Technical drawing
The downloadable PDF and drawing-sheet image show the enclosure layout. The supplied drawing is drawing revision v4 accompanying Fusion model v15.