HyperTough Power Strip Holders - 6 Styles

I was tired of my power strips sliding around on the floor and behind my desk, so I made these holders for the HyperTough 6-outlet power strip (the cheap one from Walmart). A holder on each end cradles the strip, and they screw into a wall, desk leg, or the side of a shelf to keep it up and out of the way.

There are 6 styles so you can pick what fits your space:

• Closed End with Tabs in Front

• Closed End, Flat, with Side Holes

• Closed End, 45° with Side Holes

• Open End, 45°

• Wire End, Flat, with Side Holes (lets the cord pass through)

• Left Long Tab, 45° with Side Hole

Typically you'll use one closed end for the top and the wire end on the cord end. The 45° versions angle the screw tabs for mounting in a corner or on a narrow upright.

A 3MF with all of the holders is also included.

Parts

• 2 small wood screws per holder

Assembly

Slide a holder onto each end of the power strip, hold it where you want it, and screw the tabs into the wall or furniture.

Attributions

None, my original design.

Joke of the Design

Just a quick original joke to celebrate the posting of this new design (it helps if you have low expectations):

"My nose is exhausted, it's been running all day."

Now pick yourself up off the floor and GET PRINTING!

Print Settings

• Rafts: No

• Supports: No

• Layer height: 0.12 mm

• Infill: 15%

• Material: PLA