EliteDesk Mount for Lenovo ThinkCentre TIO3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
EliteDesk Mount for Lenovo ThinkCentre TIO3
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
Was given the task to mount an Elitedesk to a Lenovo monitor, yes it's an old school monitor!
Even if it’s a niche retrofit, this print gives a second life to the robust Lenovo Tiny-in-One (TIO3) monitor stand by allowing you to attach an HP EliteDesk Mini PC directly to the main vertical column.
this sleeve design slides securely over the stand post for maximum strength and stability.
Features
Form-Fitting Sleeve: Custom-molded to slide smoothly down the TIO3 stand column for a clean, integrated appearance.
VESA Compatible: Bolts directly to the standard rear VESA mounting holes on HP EliteDesk Mini models.
Installation Steps
Detach the base plate from the bottom of the Lenovo TIO3 stand post.
Slide the printed mount (blue section in rendered preview) down from the bottom of the column to the desired height/shoulder.
Reattach the base plate to the stand.
Secure your HP EliteDesk Mini to the bracket plate using 4× VESA screws.
Hardware Required
4× VESA Screws: Standard M4 screws (typically M4 x 8mm–10mm) to secure the PC to the printed mount.
Recommended Print Settings
Material: PETG, ABS, or ASA recommended for structural integrity and heat resistance near the PC exhaust/chassis. High-wall PLA can also work well due to the rigid closed-sleeve design.
Wall Loops / Perimeters: 4–5 walls (important for strength around the VESA screw holes and sleeve shoulder).
Infill: 25%–30% (Gyroid or Grid).
Layer Height: 0.20mm.
Supports: Minimal or none required depending on print orientation (oriented vertically on the flat sleeve face).