Buddy3D Core One Camera Lid – 10x3 magnets + Wi-Fi antenna shield compatible (remix of Angle Mod v2)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the Core One Buddy3D angle-mod lid v2 for 10x3 mm round magnets, with clearance for the Wi-Fi antenna shield.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- GNU General Public License v2.0
This is a remix of DvG3DAtelier's "Camera lid remix v2 (round magnets only)" for the Buddy3D camera on the Prusa CORE One. Same improved camera angle, but:
- Uses 10x3 mm round magnets instead of 10x2 mm.
- Works with the Wi-Fi antenna shield (antenna-shield-core-one). With the original v2 lid the shield sticks out about 1 mm past the surface that touches the frame, so the camera can't sit flat with the shield installed. In this version the contact pads on both ears are 2.0 mm thicker, which gives the shield about 1 mm of clearance.
HARDWARE
- 2x neodymium magnet, round 10x3 mm
- 2x M2 screw (reuse the original ones)
- CA glue (superglue)
ASSEMBLY
1. Glue one magnet into each ear pocket with a drop of CA glue, pressed against the bottom of the pocket (the frame side). The pocket is deeper than the magnet (about 1 mm of play), so without glue it will rattle.
2. Screw the lid onto the camera body back with the 2 original M2 screws.
3. Install the antenna shield as usual.
4. Put the camera on the frame.