Battery Cover 45×25 mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement battery compartment cover, 45×25 mm, with rails and a latch. Print in PLA or PETG.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Fit is untested and may crack in PLA. PETG recommended. Not for button or coin-cell battery compartments. If you print one, please post a photo and say whether it was tight or loose.
A replacement battery compartment cover, 45×25 mm, with rails and a latch. Measure the slot width between the rails before printing.
Print settings: PLA or PETG, printed flat.
Before you print: measure your original part first and print a quick fit test. Not for parts carrying load, pressure, heat or electricity.
Licence: CC BY-NC-ND 4.0, personal non-commercial use.