KEYS, COATS, HUNG RIGHT — Wall Hook Set (Key Rail + Hook Pair + Single Tab Hook)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Three different wall hooks — not three sizes of one hook: a key rail, a hook pair and a single tab hook.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Three different wall hooks — not three sizes of one hook. (1) A 220 mm key rail with five evenly spaced hooks for keys, lanyards, badges and dog leashes; each hook is 12 mm wide and 6 mm thick with an upturned tip, so rings stay on. The rail mounts with two 7x7 mm square screw holes, one at each end (screws not included — use screws suited to your wall type). (2) A pair of general-purpose wall hooks for coats, bags, hats, towels and backpacks — print once, hang two. Each hook sits on a 50x50 mm mounting plate with two 7x7 mm square screw holes (screws not included), and the 16 mm wide, 6 mm thick fin with an upturned tip reaches about 51 mm out from the wall. (3) A single wall hook with side screw tabs: a 60x80 mm back plate with a tab on each side, each tab carrying a real 8x8 mm screw hole (screws not included), and an 18 mm wide, 6 mm thick fin with a 45-degree diagonal and upturned tip reaching about 52 mm out from the wall. Print in PLA at 0.2 mm layer height, 15-20% infill, NO supports, flat on the bed.