Netgear GS108 Switch Mount for Hager volta Mounting Plate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Skeleton bracket to hang a Netgear GS108 switch (ports up) on a Hager volta mounting plate with 2 × M3 screws.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 0
- Makes
- 0
- Views
- 5
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Bracket to mount a Netgear GS108E (v4, metal housing 158 × 101 × 29 mm) in a Hager volta multimedia enclosure. Ports face up, the switch stays open on all sides for cooling.
How it works
The switch hangs on two printed hooks using its own cross-shaped keyhole (80 mm apart): push the hook heads through the openings, slide the switch down 5 mm – done.
The four rubber feet (134 × 62 mm apart) rest on elongated pads that cover both the insert and the final position.
The hooks are 1 mm lower than the feet, so the feet are slightly preloaded and the switch doesn't wobble.
Mounting
4× M3 screws, countersunk
Horizontal slots: hole spacing 40–60 mm, vertical spacing 50 mm
Use M3 × 10 or thread-forming screws 3.5 × 10 for plastics, or M3 × 14–16 with nuts if you can reach the back of the plate
Print settings (Prusa MK3S, PETG)
0.2 mm layer height, 4 perimeters, 15–20 % infill
No supports, print as oriented
approx. 25 g filament