Netgear GS108 Switch Mount for Hager volta Mounting Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skeleton bracket to hang a Netgear GS108 switch (ports up) on a Hager volta mounting plate with 2 × M3 screws.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 5
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Bracket to mount a Netgear GS108E (v4, metal housing 158 × 101 × 29 mm) in a Hager volta multimedia enclosure. Ports face up, the switch stays open on all sides for cooling.
How it works
The switch hangs on two printed hooks using its own cross-shaped keyhole (80 mm apart): push the hook heads through the openings, slide the switch down 5 mm – done.
The four rubber feet (134 × 62 mm apart) rest on elongated pads that cover both the insert and the final position.
The hooks are 1 mm lower than the feet, so the feet are slightly preloaded and the switch doesn't wobble.
Mounting
4× M3 screws, countersunk
Horizontal slots: hole spacing 40–60 mm, vertical spacing 50 mm
Use M3 × 10 or thread-forming screws 3.5 × 10 for plastics, or M3 × 14–16 with nuts if you can reach the back of the plate
Print settings (Prusa MK3S, PETG)
0.2 mm layer height, 4 perimeters, 15–20 % infill
No supports, print as oriented
approx. 25 g filament