Urevo Strol 2E treadmill cup/bottle holder attachment

A replacement for the next to useless plate that comes with the Urevo Strol 2E treadmill. The original provides only a steep, flat area to lean things, but that doesn't help much with managing my big-ass water bottle. This model provides a cup/bottle holder, and a slightly less steep plate to put your phone or whatever on while you use the treadmill.

The inner diameter of the cup holder is 82mm and should accommodate most cups and bottles.

Printing

Prints in three parts: A connector, the main plate, and the cup holder.

I suggest using PETG and 3+ walls for strength, especially if your water bottle holds a lot, which will put stress on the print. Use supports. I used 15% 3D honeycomb infill. Suggested print orientation is the one from the STLs, which is the same as in the 3MF files. You can print the cup holder part on its side for increased strength (I'd definitely do this if I were printing in PLA), but that will require significantly more material used for supports. It shouldn't be required if using PETG, though (unless you're drinking molten steel, but then you have bigger problems to worry about).

Assembly

After printing, remove the supports, push the connector piece into the main plate, making sure you get the hole for the cup holder on the side you want it on. You might need to use a good amount of force to get it in all the way; the tolerances are intentionally tight so the pieces won't separate mid-use and send your bottle plummeting to the floor. Finally, slide in the cup holder from the top. You can use glue to make sure everything sticks together, but it is designed in such a way that glue shouldn't be necessary.