1 / 1
Shaft ID Strip — find out what shaft your broken knob actually is — image 1

Shaft ID Strip — find out what shaft your broken knob actually is

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Six sockets on one strip to identify a knob shaft by feel: round 6 and 6.35 mm, D-shaft flats 1.2, 1.5 and 1.8 mm.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
2
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

A knob cracks, you go looking for a replacement, and the trail goes cold: the part is discontinued, or it's $40, or the listing just says "fits most 6 mm shafts." So you decide to print one. Then you hit the actual problem, which is that you don't know what shaft you've got.

6 mm D-shafts are the worst for this. The diameter is easy. The flat isn't. Depending on who made the shaft, the flat is cut 1.2, 1.5, or 1.8 mm deep, and in practice calipers don't settle it — the differences are small, the shaft is usually still inside the machine, and a knob printed for the wrong depth either spins loose or cracks at the hub the first time you force it.

This strip replaces the measurement with a test. Six sockets on one plate:

round 6.0 — round 6.35 (1/4") — D-shaft 6.0 with 1.2, 1.5 and 1.8 flats — D-shaft 6.35 with a 1.5 flat

Print it in whatever is already loaded in your printer. It goes on the bed flat, no supports. Push the sockets onto the shaft one at a time. The one that grips without being forced is your answer.

Two things it doesn't do. There are no splined sockets. I haven't found spline tooth geometry I trust, and a gauge that names the wrong shaft is worse than one that says nothing, so splines wait until the geometry is sourced properly. And if none of the six grips, that usually means your shaft is splined or an in-between size. Worth knowing before you print three knobs, at least.

One assumption to flag: the 6.35 D-socket uses the 1.5 mm flat, the middle of the documented range, because I couldn't find a standard that pins it down. If yours turns out to be something else, that's exactly the kind of thing I want to hear.

If you print it, leave a comment with which socket gripped and what the knob belongs to. Washer timers and dryer controls are what I expect most, but the odd ones are more useful. That list of real shafts is what the knob generator I'm testing gets built from.

Print settings: 0.2 mm layers, 3 walls, PLA or PETG, no supports.

The OpenSCAD source was written by an AI agent (Muse) under the studio's direction; the geometry is parametric, the parameters are human-set, and the files were verified by automated checks before publishing.

Tags