Snap-In Cable Clip Set: 3 Sizes, Adhesive or Screw-On (+ Triple Clip)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Snap-in cable clips for 3-10 mm cables. Adhesive or screw versions, triple clip, 12-piece plate. No supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Snap-In Cable Clip Set, designed by Kalfa Garage.
Tidy charger, lamp, TV and monitor cables along desks, walls, skirting boards and under shelves. Push the cable in, it clicks into the C-ring and stays.
Sizes: S for about 3-4.5 mm cables (phone/USB), M for about 5-7 mm (laptop chargers, HDMI), L for about 8-10 mm (thick power leads), and a triple clip for three 4.5-5.5 mm cables side by side.
Versions: adhesive clips have a flat base for a 12 x 12 mm square of double-sided foam tape; screw clips add a tab with a countersunk hole for a 3 mm screw. plate_mixed_set_12pcs.stl prints 4 S, 4 M, 2 L and 2 triple clips in one go (153 x 36 mm).
Print settings: print as exported, on the side (the C profile flat on the bed), so the layers follow the ring and the snap flexes without cracking. No supports (the screw hole is teardrop-shaped). PLA or PETG (PETG flexes better), 0.2 mm layers, 0.4 mm nozzle, 3 walls, 20% infill. Use a brim if your first layer is weak; the parts are small.
Estimates from the mesh (not sliced): about 1-2 g per clip, about 14 g and 40-60 min for the 12-piece plate.
Note: the images are renders, not photos of a print. Made with AI-assisted tools.