1 / 2
Starline car key fob case (small ear + original ear) — image 1
1 / 2

Starline car key fob case (small ear + original ear)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Starline key fob case: rounded edges, no "Starline" text, compact side key-ring ear or original slo

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
7
Reviews
0

Updated at source:

Model information

Category
Props
License
Apache License 2.0

Starline key fob case.

What's changed vs. the original

  • "Starline" text removed from the button half (Starline32) – the back is now smooth; the button ring is kept.

  • Outer edges of the back rounded much more (R1.2 mm on Starline32, R1.4 mm on Starline31).

  • Width reduced by 0.6 mm (0.3 mm off each outer side wall): 27.3 → 26.7 mm.

  • Starline31 back made 0.5 mm thinner: 5.0 → 4.5 mm. Starline32 back left at 4.0 mm so the button area stays strong.

  • Inside geometry is unchanged 1:1 – cavity height, PCB supports, snap latches and battery pocket are the same as the original, so the board, button and battery contacts fit as before.

  • Two key-ring options:

    • Small ear – the big slot is cut away and only a small rounded ear with a ring slot remains on the side, blended into the body with smooth transitions. The ear is mirrored on the two halves, so they line up when the case is closed.

    • Original ear – the original wide key-ring slot.

Files

File

Part

Starline_case_small_ear_1.stl

Button half (top), small ear

Starline_case_small_ear_2.stl

Battery half (bottom), small ear

Starline_case_default_ear_1.stl

Button half (top), original ear

Starline_case_default_ear_2.stl

Battery half (bottom), original ear

Print one Starline32 + one Starline31 from the same set (small_ear with small_ear, default_ear with default_ear).

Dimensions (closed case footprint): 26.7 × 53.1 mm; parts 4.0 mm (32) and 4.5 mm (31) thick.

Print settings

  • Orientation: flat outer back on the bed, open side up (as exported). No supports needed.

  • Layer height: 0.12–0.16 mm (thin walls and small details).

  • Walls: 3+ perimeters, infill 100% (the parts are mostly walls anyway).

  • Material: PETG or PLA; PETG/ABS/ASA recommended if the fob lives in a car or pocket.

  • Nozzle 0.4 mm. Turn on "detect thin walls" / Arachne for the latch walls.

  • If the halves snap too tight, use slight XY hole/contour compensation (−0.05 mm) instead of scaling the model.

Notes

  • Do not scale the models – the inner fit is 1:1 with the original and scaling will press the button or move the battery away from its contacts.

  • Fit depends on your printer's tolerances; test with your own board before use.

Tags