TRMNL 7.5" (OG) DIY Kit – Slim & Sleek, 20° Tilted Display
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement mainboard case for DanioZg's Slim & Sleek TRMNL 7.5" enclosure that leans the display back 20° over the case
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 9
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
A remix of DanioZg's Slim & Sleek case for the TRMNL 7.5" (OG) ePaper Display DIY Kit by Seeed Studio. The original holds the display at 90°. This version leans it back 20° over the mainboard case, which still sits flat on the desk.
What's changed
Only the mainboard case is different. Its front face is now angled at 20°, with the two frame screw holes and the ribbon cable slot re-cut to match. Everything behind the front wall is identical to the original.
What you need
This file: mainboard_case_tilt20_v2.3mf (replaces mainboard_case.3mf)
From the original model, unchanged: display_frame, display_bracket, mainboard_top, battery_bracket
The same hardware as the original, including the two M3x8 frame screws
Printing
Same orientation as the original case (bottom on the bed), no supports. Printed on a Prusa MK3S in PLA at 0.2 mm.
Assembly notes
Follow the original assembly manual.
The two frame screws now go in at 20° from behind and slightly below, so tighten them with the unit lifted or lying face-down.
The ribbon cable travels about 5 mm further than in the original. I used the longer cable.
Use a short screwdriver for the lid screw, since the display leans over it.
The bottom edge of the display sits about 1 mm above the desk rather than resting on it.
Credit
All credit or the original design goes to DanioZg. The geometry change in this remix was made with the help of an AI assistant (Claude).