INDX Dock 1515 Spacers – 9 docks on a 350 mm bar (35.3 mm pitch)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix: 9 INDX docks on a 350 mm 1515 bar (35.3 mm pitch, 20 mm free each end) + left-end angle spacer.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This is a remix of BlueTip's INDX Dev Kit Dock 1515 Spacers. All of the design credit goes to the original; I mainly changed the lengths.
The original spacers give about 45 mm between docks. I wanted more docks on a 350 mm 1515 front bar and still needed about 20 mm free at each end for the bar mounts. So I rebuilt the same spacer shapes with new lengths.
SPACING
Dock pitch is 35.3 mm, and 9 docks fit on a 350 mm bar.
With the end pieces, 20.35 mm of bar stays free at each end.
I checked the pitch against Bondtech's INDX reference geometry (INDX_simplified_1.19.step), using the bare toolhead with no 4010 or CPAP fan adapter. The toolhead needs at least 33.6 mm between docks to dock a tool without hitting the tools parked on either side, so 35.3 mm leaves about 1.7 mm of clearance.
If you use the 4010 or CPAP part-cooling adapter, this pitch is too tight. The minimum is about 42.1 mm with the 4010 adapter and 39.9 mm with the CPAP adapter, so use the original spacers instead.
PARTS (print quantities for 9 docks)
indx_dock_spacer_9dock_350mm: angle spacer between docks, 26.05 mm, print 8
indx_dock_spacer_left_end_angle: left end, angle runs under the first dock's cap, 37.65 mm, print 1
indx_dock_spacer_right_end_20mm: right end, plain end spacer like the original (lengthened 18 → 20 mm, hole in the lower wall only), 20 mm, print 1
HARDWARE AND PRINTING
Each part takes one M3x8 screw with a square nut in the lower side T-slot of the 1515 bar. The top wall has no hole. The original's nut carrier works here too.
Print with the base plate on the bed, without supports. The original was printed in ASA at 25% infill.
I have not test-printed these yet. The fit was only checked in CAD, so print one first and check it on your bar and docks before you print the rest.
