1 / 4
AS5600 Magnetic Encoder Mount – Drop-in Potentiometer Replacement (M10) for Thrustmaster FFB Wheel — image 1
1 / 4

AS5600 Magnetic Encoder Mount – Drop-in Potentiometer Replacement (M10) for Thrustmaster FFB Wheel

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Swap the worn-out pot in your wheel for a AS5600 magnetic encoder. M10 panel mount, 607 bearing, geared-shaft friendly

Rating
0 / 5
Likes
1
Downloads
2
Makes
0
Views
21
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

Replaces the potentiometer in an old Thrustmaster force feedback wheel with an AS5600 magnetic encoder. No contact means no wear, no scratchy signal, and no end stops, so the shaft can turn as many times as you like.

Features

  • M10 thread, 5 mm tall and 2mm part with no threads, fits the stock pot hole

  • 607 bearing carries the shaft, so it’s smooth and takes side load

  • The outer shaft tolerance is designed so you can fit a gear on it

  • The body is held by 2 × M3 heated inserts in the ears

  • The magnet sits hidden inside the shaft end, with a 1–1.7 mm gap to the chip

  • Also fine for other builds that need a pot-sized encoder (pedals, handbrake, etc.)

Bill of materials

  • 3 × printed parts (STL included)

  • 1 × AS5600 module

  • 1 × 6×2 mm diametral magnet (thicker ones may fit too)

  • 1 × 607 bearing

  • 2 × M3 heated inserts + 2 × M3 screws

  • 1 × M10 nut (not included)

  • CA glue for the magnet

Assembly

  1. Press the heated inserts into the ears.

  2. Glue the magnet into the shaft end. Check the polarity and that it sits flush.

  3. Press the 607 into the body and fit the shaft.

  4. Clip the AS5600 board under the body and set the gap to 1–1.7 mm.

  5. Mount it in the panel with the M10 nut.

Print settings

  • Material: PETG (tested). PLA should work too.

  • Layer height: 0.3 mm worked, but 0.25 mm or finer is better for the shaft and bearing fit

  • Supports: yes, for biggest body part

  • Infill/walls: 1-3 walls, 10% infill, it does not work with big loads

Tested with: Arduino Pro Micro, works really well.

Known quirk: you may see occasional ghost jumps of about 0.1°. That’s roughly 1 LSB of the AS5600’s 12-bit resolution (about 0.088°), so it’s normal sensor noise. A small deadband or light filtering in firmware fixes it.

Tags