AS5600 Magnetic Encoder Mount – Drop-in Potentiometer Replacement (M10) for Thrustmaster FFB Wheel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Swap the worn-out pot in your wheel for a AS5600 magnetic encoder. M10 panel mount, 607 bearing, geared-shaft friendly
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Replaces the potentiometer in an old Thrustmaster force feedback wheel with an AS5600 magnetic encoder. No contact means no wear, no scratchy signal, and no end stops, so the shaft can turn as many times as you like.
Features
M10 thread, 5 mm tall and 2mm part with no threads, fits the stock pot hole
607 bearing carries the shaft, so it’s smooth and takes side load
The outer shaft tolerance is designed so you can fit a gear on it
The body is held by 2 × M3 heated inserts in the ears
The magnet sits hidden inside the shaft end, with a 1–1.7 mm gap to the chip
Also fine for other builds that need a pot-sized encoder (pedals, handbrake, etc.)
Bill of materials
3 × printed parts (STL included)
1 × AS5600 module
1 × 6×2 mm diametral magnet (thicker ones may fit too)
1 × 607 bearing
2 × M3 heated inserts + 2 × M3 screws
1 × M10 nut (not included)
CA glue for the magnet
Assembly
Press the heated inserts into the ears.
Glue the magnet into the shaft end. Check the polarity and that it sits flush.
Press the 607 into the body and fit the shaft.
Clip the AS5600 board under the body and set the gap to 1–1.7 mm.
Mount it in the panel with the M10 nut.
Print settings
Material: PETG (tested). PLA should work too.
Layer height: 0.3 mm worked, but 0.25 mm or finer is better for the shaft and bearing fit
Supports: yes, for biggest body part
Infill/walls: 1-3 walls, 10% infill, it does not work with big loads
Tested with: Arduino Pro Micro, works really well.
Known quirk: you may see occasional ghost jumps of about 0.1°. That’s roughly 1 LSB of the AS5600’s 12-bit resolution (about 0.088°), so it’s normal sensor noise. A small deadband or light filtering in firmware fixes it.