Wilderness Krate spacer for middle rod holder risers
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€7.37 – €9.01 net (excluding VAT)
For file: 2-Krate-braces_0.3mm_PETG_MK3S_6h47m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €8.19 excluding VAT (range midpoint).
- Weight reported by the author
- 141 g
- Print time reported by the author
- 6.79 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Raise the middle rod holders of your Wilderness Systems Krate without cutting the tie-downs.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 36
- Makes
- 0
- Views
- 1,048
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
The Wilderness Krate fishing crate allows for 6 rod holders, but you have to lower the middle two or cut off the center tie-downs. With this spacer, you can have the height and an unblemished Krate.
In addition to the 4 spacers, you will need:
- four 1/4 in.-20 x 3/4 in. Hex Socket Head Stainless Steel Socket Cap Screws*
- four 1/4-in x 20 Stainless Steel Nylon Insert Nuts**
- two Wilderness riser brackets
*Lowes had the screws in-store, but the website doesn't seem to list them.
**You can also substitute metric-equivalent screws and nuts. Stainless steel is recommended.
I printed with Prusament orange PETG with 50% infill for increased heat resistance and structural integrity. I lightly hammered the nuts into the holes. I used bobstro's supports on the build plate only (see screenshot).