Wilderness Krate spacer for middle rod holder risers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raise the middle rod holders of your Wilderness Systems Krate without cutting the tie-downs.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 1048
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
The Wilderness Krate fishing crate allows for 6 rod holders, but you have to lower the middle two or cut off the center tie-downs. With this spacer, you can have the height and an unblemished Krate.
In addition to the 4 spacers, you will need:
- four 1/4 in.-20 x 3/4 in. Hex Socket Head Stainless Steel Socket Cap Screws*
- four 1/4-in x 20 Stainless Steel Nylon Insert Nuts**
- two Wilderness riser brackets
*Lowes had the screws in-store, but the website doesn't seem to list them.
**You can also substitute metric-equivalent screws and nuts. Stainless steel is recommended.
I printed with Prusament orange PETG with 50% infill for increased heat resistance and structural integrity. I lightly hammered the nuts into the holes. I used bobstro's supports on the build plate only (see screenshot).