Door hook, button presser with enclosure MK1 (No touching tool)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.60 – €1.96 net (excluding VAT)
For file: 45331883-690b-4848-a9f7-d8eca9884370_015mm_pla_.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.78 excluding VAT (range midpoint).
- Weight reported by the author
- 16 g
- Print time reported by the author
- 2.08 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Updated version MK2: https://www.prusaprinters.org/prints/26725-door-hook-button-presser-with-enclosure-mk2-no-tou…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 40
- Makes
- 1
- Views
- 616
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Updated version MK2: https://www.prusaprinters.org/prints/26725-door-hook-button-presser-with-enclosure-mk2-no-tou
Many of the other no touching tools do not have any type of enclosure which we will touch it with our hands or clothes eventually. Even those with an enclosure, it is a separate enclosure so it is not as convenient. This design is inspired by the army knife design where you could pull the hook out and store it without a separate enclosure!
Another main point of my design is that it would lock in place when opened or closed so it would not accidentally wobble or slide out of place. (There is a slight click when fully opened and closed, which is a bit satisfying, but don't fidget with it after using it in public!)
It could also act as a keychain or just put it in your pocket when going out.
Print instructions
G-Code is provided for MK3S printers
Model orientation when printing is shown on the provided pictures
The shaft is printed horizontally to increase strength
Around 2 hours of print time
Print settings:
0.15mm
15% infill
3 perimeters
Support on build plate only (for the horizontal shaft)