Artillery Sidewinder X1/X2 Part Cooling Fan Duct
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Part cooling fan duct for use with 5020 fan upgrade.
- Rating
- 4 / 5
- Likes
- 57
- Downloads
- 466
- Makes
- 7
- Views
- 3,168
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution
This is a model based on Motogeepie's amazing design.
(https://www.thingiverse.com/thing:3927320)
After trying half a dozen of various ducts I have settled for this.
I have been using this duct for the past 2 years and I am very satisfied with its performance.
The original design is for the stock 4020 fan but I have modified it to suit a larger 5020 fan for a slightly better cooling performance.
The front half of the duct model (grey in the screen-shots) is intact only the back is edited to suit the larger fan.
Printing:
Front half no supports needed. Rear needs support as well as support blockers inside the air paths. I also have two pictures showing the Gcode preview so you can see where I used supports and where I haven't.
I also used draft shield as I printed this in PETG without an enclosure and certain thin parts would de-laminate without the shield.
I do not recommend printing this in PLA, it will melt because of the bed heat and the close proximity. I know this from experience. ;)
Big thanks to Motogeepie for publishing the original design in STEP format. This greatly helped me to do the modifications for the larger fan. In the same spirit I have also included a STEP file in case someone decides to do further modifications to it.