Spoolholder for Cubic- and Delta-printers with room for casing

A spoolholder for Cubic- and Delta-printers. The holder can hold spools up to a width of 95 mm. I use a variation of this spoolholder for all my printers and it works great. Due to the wide "bed" of the spool-holder the spool wobbles less than it does at the broomstick-like holders.

The bolts are sunken so they can not hook up your spool. The design is strong and solid (see printing notes).

Because the "bed" has an offset of 4mm, you can use it with your (DIY) casing. The thing has a footprint of 55x20 mm (HxW)

Mounting tips:

• If the spoolholder does not fit right (plating to thick for one or another reason) , use washers or better the included spacer (1 mm thick, scale it up in Z-direction while slicing).
• You need 2 M4x8 mm bolts and T-nuts (when installed on 2020 like alu-frame).
• Use the inlay for a little extra bling.

Happy spoolholding :)

---

Other members of the Spoolholder-family:

• Spoolholder for Cartesian printer: https://www.thingiverse.com/thing:3064326
• AnyCubic Kossel: https://www.thingiverse.com/thing:3020295
• AnyCubic 4MAX: https://www.thingiverse.com/thing:3547789

Print Settings

Rafts:

No

Supports:

Resolution:

0.2 or 0.3

Infill:

Notes:

Use 5 walls/perimeters for a nice strong print without shaking because of futile infill in 90% of the print. Your print will be stronger and the saving with less walls is minimal.

Category: 3D Printer Parts