Ender 3 Xmas House LCD cover

Small wood house with snow on the roof (and some tracks on it ;)) that you can use as an LCD cover for decoration or just to shade the glow

More photos:
https://www.instagram.com/p/CXn5I0hN1jm/
and
https://www.instagram.com/p/CXn53mbteN5/

Additionally there is an xmas tree shaped knob with a star on top

---

House is cut with 22,5dgr angle as LCD metal frame on Ender 3 and will fit it's hole - there is a model without a cut so you can use it for different printers lcds if it is with the same proportions
The base is 78x48mm. The frame hole should have around 80x52mm - if it is slightly smaller than the house you can resize the model 

It is printed in two parts

---

IMPORTANT
The top of the model will stick above the bed
With original printer setup you can't print at least up to 2cm on the right side because the extruder will collide with the house
With moddified extruder (for example with bigger fans on sides) it will need even more space so keep it in mind

---

Made in Blender 3D
Printed on Creality Ender 3

---

Roof will need supports (unless you will print 'roof_no-supp' but it may look little different when put on lcd)
You can use the 'supp-roof' file and set it to 'print as supports'. Supports should be in the exact same possition as the roof
Sometimes in Cura the roof or the supports models may be rotated by 180dgr. Remember that the hole in supports should be under the chimney hole

Models printed with 0.2mm layer hight but it is reccomended to print with better quality
House printed with 3 walls
10% infill (used just on some parts on the roof)

Tree knob was printed with 2 walls (but you can use 3 for more strenght) - it may be better to print it with PETg
No infill
Changed the color near the top for golden star

---

Check my collection for more Winter holiday decorations