MOSFET Controller Snap Fit Case - M3 Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
2020/2040... mountable snap fit case for a common mosfet controller board. (33.7x17mm)
- Rating
- 5 / 5
- Likes
- 27
- Downloads
- 137
- Makes
- 1
- Views
- 456
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A case designed for your average MOSFET controller board. Approximately 33.7 x 17mm.
Prints fast, clean, and small - pop it off the build surface, and use it instantly.
Mounts solo, or side by side on 20XX extrusion / others. Mounting recessed for M3 hexcap - I used printed M3 slot nuts to secure to 2040.
It is almost always required that you trim the bottom post mounts for it to sit flush.
Side trimmer, fingernail clipper, etc - trim the excess metal points. Very easy.
Not much to this model -printing at any layer height/line width/nozzle/etc should do.
PARTS (if mounting):
2x M3x6 Hex Cap Bolt
2x M3 T-Nut