Hexagonal Hole Mounted LED Strip Bar for MK3S - Fits on Mini and MK3S Buildplate
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.94 – €2.37 net (excluding VAT)
For file: led_strip_mod_03mm_pla_mini_1h49m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.16 excluding VAT (range midpoint).
- Weight reported by the author
- 34 g
- Print time reported by the author
- 1.82 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
I saw Martin44's LED Bar which mounts into those mysterious hexagonal holes on top of the Z axis, but it's too big to…
- Rating
- 4.857 / 5
- Likes
- 48
- Downloads
- 171
- Makes
- 5
- Views
- 1,651
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
I saw Martin44's LED Bar which mounts into those mysterious hexagonal holes on top of the Z axis, but it's too big to fit on the MK3S buildplate as-is. I split it into three pieces - it fits on the Mini now - and added pin alignment holes in Blender.
Uses a small piece of filament as the alignment pins. You'll need to superglue the pieces all together.
I applied a USB LED strip that was ~$1.30 so anything you have should work.
Does not interfere with the extruder or reduce available print area.
Also, yes, I printed an upgrade for my MK3S on my Mini.
Print instructions
Draft settings are fine. I used 0.3mm layer height and 5% gyroid infill (started from the 0.25mm DRAFT preset for the Mini)
You'll need two small pieces of 1.75mm filament to use as pins, cut an angle on the ends and the filament will slide into place snugly.
Super glue the pieces together and let it cure properly.
I used a heatgun after assembly to open the completed U shape a little bit - avoiding the pin areas when bending - since I printed in PLA and didn't want the tension of snapping the strip into the hexagonal holes to split the part or the superglued surfaces.