1 / 12
Copperhead + BMG Direct Drive for Ender 3 / CR-10(S) Tank Remix — image 1
1 / 12

Copperhead + BMG Direct Drive for Ender 3 / CR-10(S) Tank Remix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

<UPDATE: I have successfully printed PC+ at 260C for 5+ hrs with no warping of any of the parts.

Rating
0 / 5
Likes
2
Downloads
45
Makes
0
Views
1,124
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

<UPDATE: I have successfully printed PC+ at 260C for 5+ hrs with no warping of any of the parts. Also the hotend cooling with the 4010 pulling air across the heatsink worked beautifully.

I have printed with PLA, PETG, and PC+ and have had no issues with clogging.

Retraction settings for my setup are down to .4mm and stringing is non existent, even with PETG.

UPDATE>

This is a remix of the "Tank" from Greg191134 for the Slice Engineering Copperhead hotend.

Most parts have been significantly remixed to accommodate the new hotend. Fragility of original design has been resolved.

The hotend cooling solution has also been significantly reworked to use the stock Ender-3 4010 part cooling fan in a unique configuration that will exhaust the heat upwards (ala Hemera) as to not create any drafts when printing technical materials. At last this fan has a good use! One corner will need to be clipped to clear backplate bolt.

The part cooling fan shroud is the same as Scope6666's part, but the bracket has been reworked a little for quality of life improvements. Not sure yet if the fan is aimed perfectly as the Copperhead is a little taller, time will tell.

I also beefed up the BL-Touch mount and put in a center hole for pin access. Also included are some shims to help get the BL-Touch height where you like it.

Most hardware is the same as the original tank design, with exception of the hotend fan. Stock Creality screws should work here.

Tolerances are tight in order to ensure a secure fit, your printer will need to be well adjusted for success here.

I would print in PETG (pictured) for best results, but this should work in PLA if your make yourself a silicon sock for the heater block. I used Permatex Ultra Copper silicon and it worked nicely.

Print instructions

I would print with 4 perimeters and 4 top/bottom layers for best strength.

PETG of "better" filament recommended as PLA might deform (sock highly recommended if going PLA).

Tags