(WIP) Power Bank 3S2P "6 in a row" 18650 Connector Case and Backplane cable guide
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
WIP design of a very thin and light 6X 18650 connector case and a backplate for guiding cables for a BMS HW-544
- Rating
- 0 / 5
- Likes
- 51
- Downloads
- 240
- Makes
- 0
- Views
- 1,962
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I wanted to create a Power Bank in a very thin box, and designed a specific battery connection holder and a backplate cable guiding, all in 39,2 mm tall. Read the document for full specs and instructions.
Hope you like it!
Note: feel free to send me any kind of suggestions. I'll be updating the model and documentation as soon as I can assemble the Power Bank. This is one of my first designs, please be patient! : )
Update1: I've received and installed the battery connectors. They fit a bit tight but get the right position with some push. I would have liked bigger connectors but it's not a bad result (see the new pictures). The cables guide fit in place with the connectors.
Update2: I received some orders from Aliexpress with connectors, switches, an so on, and I could finish the job. I had problems soldering (I'm still a beginner) and with the battery connectors that apparently don't make their job enough good.
Lessons learned: 1) Although using copper cable was a good idea to my mind (to improve current flow), I would never do it again in the future because it's difficult to work with. 2) I also thought that it could be a good idea to use batteries with connectors (easier to remove or change) instead of soldering them, but the connectors springs started to fail, so I think that I won't do it again.
It was my first job and now I'd probably do everything different, but I learnt a lot and really enjoyed the process.
