Caliper case Mitutoyo 150mm 530-104 V2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I've updated the case I made some time ago so it becomes easier to print and more rigid
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 152
- Makes
- 1
- Views
- 1,055
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
I will print it soon, by the way it needs :
2 M3 worm bolts around 1cm
2 neodymium magnets 8mm diameter with 3mm thickness.
The new version is better because it prints in two parts without supports and doesn't need any glueing like the old version did.
There also a small fix so that the calipers sit better inside the case and they don't move that much.
There was a problem with the holes being 4mm and m3 worm nuts not even screwing. I am sorry about that, I've updated the file.
I've also made another version that needs 4 neodymium magnets. Due to warping it should fix the lid and make it straighter. I'm not quite sure if that works since I don't care about the aesthetics.