Mitutoyo Micrometer Replacement Battery Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement Mitutoyo Micrometer Battery Cover LID 04AAC124.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 180
- Makes
- 0
- Views
- 821
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remixed project of the Mitutoyo Micrometer Battery Cover by GreatOldOne.
After printing the original design by GreatOldOne, to replace a broken Battery Cover for our 1-2” Mitutoyo Mic. I noticed that the fit was not as I expected as it was recessed and didn’t sit flush with the body of the mic.
About the Design:
I completely remodelled the part in Fusion 360, taking direct measurements from the original broken battery cover I have also included a dimensional drawing reference. I made a few improvements first; I cleaned up the start Thread (Fig.1) I also reduced the interference fit between the body and insert.
If you have any questions, please feel free to contact & if you print it, please share your make and let me know the model of your micrometer.
Compatibility List:
Series 227 - Should be compatible but not confirmed.
Series 293 - Confirmed.
Series 314 - Should be compatible but not confirmed.
Series 317 - Should be compatible but not confirmed.
Series 323 - Should be compatible but not confirmed.
Series 326 - Should be compatible but not confirmed.
Series 329 - Should be compatible but not confirmed.
Series 340 - Should be compatible but not confirmed.
Series 343 - Should be compatible but not confirmed.
Series 350 - Should be compatible but not confirmed.
Series 369 - Should be compatible but not confirmed.
Series 395 - Should be compatible but not confirmed.
Series 406 - Should be compatible but not confirmed.
Series 422 - Should be compatible but not confirmed.
Printing requirement:
Layer Height 0.15mm.
Perimeters 2.
Top & Bottom Layers 4.
Infill can be set to 0% or left unchanged.
Supports Required No.
Filament:
I used Prusament PLA Jet Black worked fine I am confident that it could be printed in other Materials.
Post Production:
Remove support press-fit together if loose a small amount of glue can be used.