1 / 3
CR6 Raspberry Pi 3 5 Inch Display Klipper
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 5inch display for RPI 3 with a mount on CR6 instead of the stock display for Klipper.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 76
- Makes
- 0
- Views
- 1,955
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
For CR6 SE i replaced the stock display and firmware with Klipper and mounted a RPI 3 with a touchscreen instead, all the screws that I used are M3x16mm.
I took out the cable from the display and added a DC-DC Step Down from 24v to 5.1v to power up the pi from the printer's power source.
After you install the RPI to use the power from the printer, re do the PID tunnings because it might heat up a bit slower
For the my top of the case, i added my logo, but in the files is a clean version of it.