1 / 5
Logitech Z623 1-Inch Conduit Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount your Logitech Z623 speakers to standard 1-inch conduit.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 67
- Makes
- 0
- Views
- 1,246
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
This mount mimics the geometry of the Logitech Z623 speakers — engaging the existing screws to make for a clean mount without damaging the speaker body.
- Remove the rubber feet from the speaker's underside.
- Use M3x50 screws to fasten the mount adapter to the speaker body.
- Designer's Choice
- When necessary, use a heat gun (low heat) to introduce the printed adapter to the speaker body. This may improve fitment for printers with loose tolerances.
- When necessary, use a heat gun (high heat) to warm the M3 screws for introduction to the Z623's threaded holes.
- Use a heat gun (low heat) to warm the printed clamp at the reduced/pinched joint, and quickly install the clamp on the 1-inch conduit.
- Use M4 or M3 screws to tighten the printed clamp's grip on the 1-inch conduit.
- Use M4 screws to fixture the adapter onto the printed clamp.
The installation shows in the cover image features 1-inch conduit coated in skid-resistant 1-inch shrink tubing. This is optional, but is recommended to prevent unintentional axial movement of the speakers.