1 / 5
Logitech Z623 1-Inch Conduit Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your Logitech Z623 speakers to standard 1-inch conduit.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 67
- Wydruki
- 0
- Wyświetlenia
- 1246
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (1)Kolekcje (11)Powiązane
This mount mimics the geometry of the Logitech Z623 speakers — engaging the existing screws to make for a clean mount without damaging the speaker body.
- Remove the rubber feet from the speaker's underside.
- Use M3x50 screws to fasten the mount adapter to the speaker body.
- Designer's Choice
- When necessary, use a heat gun (low heat) to introduce the printed adapter to the speaker body. This may improve fitment for printers with loose tolerances.
- When necessary, use a heat gun (high heat) to warm the M3 screws for introduction to the Z623's threaded holes.
- Use a heat gun (low heat) to warm the printed clamp at the reduced/pinched joint, and quickly install the clamp on the 1-inch conduit.
- Use M4 or M3 screws to tighten the printed clamp's grip on the 1-inch conduit.
- Use M4 screws to fixture the adapter onto the printed clamp.
The installation shows in the cover image features 1-inch conduit coated in skid-resistant 1-inch shrink tubing. This is optional, but is recommended to prevent unintentional axial movement of the speakers.