1 / 3
Pegboard pin-punch holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A pegboard holder for a set of brass pin-punches.
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 213
- Makes
- 0
- Views
- 1,295
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
A pegboard holder for a set of brass pin-punches.
I have attached four versions:
- With, and without the sizes printed on it (in case your selection of sizes is different from mine.
- With the punches straight up/down, or tilted outwards at a 10 degree angle. Tilting them outwards makes the punches easier to access if there's something else above them on the pegboard.
Mounts on 1/4" pegboard using my lockable pegboard rivets.
Print instructions
Print it lying on its back. The holes are small enough that they turn out nice without supports.
I printed the rivets in a separate job using 0.1mm layers. They're very small and don't take long.