Aquarium Plant Hanger Basket for Aqueon 10 Gallon
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This aims to address issues I had with the original Aqueon Aquarium Plant Hanger Basket (more details in description)
- Rating
- 0 / 5
- Likes
- 50
- Downloads
- 470
- Makes
- 3
- Views
- 2,257
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Disclaimer: I printed this in PLA which is “biodegradable” I put quotes because it takes a very long time, but that being said these will have to be replaced at some point, as which I'm sure you'd want to do anyways.
EDIT: I added a rimless variant that has a 6mm gap so technically should work for upto 5mm glass safely but was designed for an Aqueon I own.
- It uses ~1oz of filament @
- 0.2mm layer height.
- 30% gyroid.
- 3 perimeters, 3 top/bottom layers.
- PrusaSlicer_2.6-alpha6 organic supports.
- Cost on a ~$0.72 1000g $25 spool.
- The SCREW should be printed at 100% Rectilinear(or similar).
I started off by shortening the gap of the bracket by 3/8" or 0.375" because it was too wide for my 10 gallon and the screw by ¼" or 0.250 (1/8" or 0.125" less). because it needed to be a tad longer an 1/8" would have saved me here. but If I shortened them both the same I would still not be touching the tank.
I then realized the pot was rotated out of canter by 5 degrees and had parts of the bracket extruding past what should be an open flow. So I fixed the geometry to make it as open and undisturbed as possible.


One of the walls near the slot was too thin to print properly so I made some extra locating geometry, cut that part out, and rolled the edges back.

I checked the thread size its "5/16-18UNC Class 1B" Id suggest if that bothers you print another SCREW to use after you open that hole up, or changing the threading to "¼-20UNC" which is a standard camera tripod screw(you could use that to form threads) in the soft plastic without a tap, but they were tough to start and I had to use pliers to thread it in, but then it was fine. Id maybe suggest tapping that hole!
Below is examples of rolled edge and locating geometry:


I also exported the STL's in the correct orientation and singled them out so its not one file.

Any comments are welcome, I included the Fusion360(.f3d) file after I've made my modifications. I also only used math so all original parameter exist(I just subtracted 0.375")