1 / 5
Cat Door Small Doggy Pet Entrance Replacement
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a cat door I modeled in tinercad to replace a friends broken one.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 61
- Makes
- 0
- Views
- 853
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Support needed for outer edge only. Weather stripping recommended.
Also recommend using the “Magnet Cartridge for Cat Door” to keep Cat Door in correct position and prevent wind from blowing it open. PRINT 2, one for door and one for threshold.
If you use the magnet cartridges, make sure thinner sides of Magnet Cartridges are facing each other so magnets can be as close as possible to each other.
PETG Recommended.
0.2 Layer Height