ELECTRIC EEL WHEEL NANO BOBBIN TO 6.0 SPACER/ADAPTER
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
this is a spacer/adapter that allows you to use Electric Eel Wheel Nano bobbins on an Electric Eel Wheel 6.0 flyer.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 50
- Makes
- 0
- Views
- 625
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
EEW Nano bobbins can be used on the EEW 6.0 flyer, but they leave a sizeable gap on the flyer rod. the bobbin can slide to the left at higher speed and drag the break band with it, which will eventually catch on the flyer arm and stop the flyer all together or worse, begin to wear your break band to the point of it snapping and breaking.
i used a rubber band around the flyer rod to hold the Nano bobbin in place, but it would gradually slide out of place and need to be pushed back. so i created this simple little tube to serve as a spacer/adapter on the flyer rod before sliding a Nano bobbin onto the 6.0 flyer. it leaves just enough of a small gap to allow for some ease for the Nano bobbin to still spin independently but prevents it from ever sliding over to the left too far, so i can spin without interruption until i need to move the yarn guides along (sadly don't have an auto winder!)
(a bit tough to see in these photos since i printed it in silver PLA so it blends in with the stainless steel rod)