Parametric springloaded battery mag
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A two-piece mag for 6 AAA batteries and a simple vase-mode holder
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 31
- Makes
- 0
- Views
- 257
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Loading the battery mag on YouTube
Print settings
Layer height 0.2mm, wall speed of around 50 mm/s. NO cooling (as low as possible).
Spring
1. aaa6_mag_spring should be printed in PETG.
2. aaa6_mag_spring can be stretched or compressed manually if needed.
3. Z-seam on aaa6_mag_spring should be placed in the corner.
Case
1. The aaa6_mag_case may be printed in PETG, though I recommend PLA due to its rigidity
2. Cooling as low as possible for aaa6_mag_case. This will ensure the best layer adhesion.
No special settings for aaa4_vase_mode
Fusion 360 file is added, you may change the dimensions to your liking. Issues may occur because of fillets, make sure to adjust them.