TTGO T-Beam T22_v1.1 20191212 Case (IPEX Version)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The idea behind this case was to create something minimal, sturdy and without any fasteners. The T-Beam is aligned…
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 97
- Makes
- 0
- Views
- 1,133
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The idea behind this case was to create something minimal, sturdy and without any fasteners. The T-Beam is aligned with the case through the use of a brace below the PCB, which locks it into place on the mounts so that there's no sliding around. A spacer on top of the PCB is used to ensure the right distance between the OLED screen and the lid. The lid uses a sliding mechanism with a very snug fit (at least with my printer and filament), so it shouldn't open by itself.
There have been multiple iterations over the placement and tolerations, so even if some of the parts look like they have the wrong dimensions, rest assured that this was the outcome of several test prints and is the way it's meant to be.
The display used is a 0.96" SSD1306, with the cutout in the lid precisely measured to only show the visible area of the display.
The buttons are labeled P, U and R for Power, User and Reset. The User button has a small nub on it, so you can find it without looking.
Print Settings
Printer:
Artillery Sidewinder X1
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
~%
Filament:
Prusament PETGOrange
Notes:
The main body must be printed standing upright, as the buttons will most likely not work otherwise.
Assembly
If you're going to solder the display onto the T-Beam yourself, i would recommend first printing the "Brace" and the "Spacer" parts, so you can align the display correctly when soldering the pins. The display should be soldered on perfectly flat and just barely touching the inner side of the spacer.
Start by installing the (disconnected) antenna, placing the inner nut and spring washer on the inside and the lock washer and outer nut on the outside. Make sure everything is nice and tight, but don't overdo it.Thread the antenna cable first through the hole of the Right Mount, the through the hole in the PCB (from the bottom up) and plug it into the connector.
Now comes the tricky part: thread the GPS antenna cable into the channel in the Right Mount (it helps to slide the mount from the back), while pulling the LoRa antenna cable slowly through the whole, while also aligning the mount of the SMA connector with the whole in the mount, while sliding it into the case, while also making sure the Left Mount makes it into the case.
I apologize for this.
I helps to do this all with the T-Beam flipped upside down, so the mounts stay in place. Good luck! ;-)
Category: Electronics