1 / 2
Ryobi One+ Router base plate - 4x2 groove
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A plate to cut a groove in a 4x2 stud with a Ryiobi One+ cordless trim router (model P601)
- Rating
- 0 / 5
- Likes
- 61
- Downloads
- 161
- Makes
- 1
- Views
- 1,187
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
While rebuilding the guardrail for my old deck, I needed to cut grooves into 4x2 studs to hold vertical glass panels. It is my first time using a plunge router and I did not trust my ability to cut in a straight line, so I made this plate to guide the router
My first attempt on an old withered 4x2 stud from the old guardrail turned out pretty good. A little too deep, but that is just a matter of my learning to set the cutter correctly.
I used Overture PETG, in space grey colour, 15% infill. PLA should work fine.