1 / 2
Anemometer V2 for Arduino
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Anemometer V2 for Arduino
- Rating
- 0 / 5
- Likes
- 29
- Downloads
- 188
- Makes
- 0
- Views
- 1,249
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Anemometer V2 for Arduino
Anemometer V1 available here: v1 printable
New Features:
- Lighter - easier to spin, less mass - less momentum.
- Integrate only one imbedded magnet.
- Lower center of gravity - more stable.
Material:
- 1 x 10x1.8mm Neodymium magnet
- A3144 hall effect sensor
- 10K resistor
- Arduino Nano
It uses 1 magnets that are inserted inside the head during the print (add a pause at layer 47 for a 0.2mm layer height - if you need information about imbedded magnet into a 3d print, post a comment or send me a pm).
Inside the body (base tube) is inserted an A3144 hall effect sensor and a 10k resistor, all plugged to an Arduino Nano.
I use a pop rivet (4mm head - 2mm pin), sharpen and inserted in the main body to let the head rotate freely.