SV06/+ Super/PINDA Mount

Update: Changed the size of the PINDA area so it fits better, there should be less chance of breakage. 

I wasn't happy with the stock inductive probe on my SV06+, so I bought an extra SuperPINDA and made this lightweight mount to cut down the weight a bunch.

Printed in PolyMaker ASA since I do a lot of high temp printing in an enclosure, but PETG would work as well.  0.2mm layer height, 100% infill

The Probe section has a spot for a nut, I used an M3x10 countersunk bolt. You can reuse the stock bolts to attach the mount to the extruder. 

Wiring is the same so it'll work on any firmware (Stock, Marlin, Klipper, etc). Crimp a new JST connector on the PINDA, matching the colors on the stock sensor. I went for a male/female connection mid-cable as I did not have the correct size.

Follow the Prusa Guide for the correct height when installing, I got noticeably better first layers. Adding the nylock mod improved it even further.

My Klipper settings I've found for the most consistent first layer while still being speedy enough to perform before every print using KAMP.

[probe]
x_offset: 24
y_offset: -20
speed: 8
lift_speed: 20
samples: 3
sample_retract_dist: 1
samples_result: median
samples_tolerance: 0.01
samples_tolerance_retries: 3

[bed_mesh]
speed: 400
mesh_min: 25, 25
mesh_max: 275, 275
probe_count: 7, 7
algorithm: bicubic
horizontal_move_z: 3
fade_start: 1
fade_end: 10
fade_target: 0