Prusa MK3S PTFE reverse Bowden conical thread holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
prusa mk3s ptfe reverse bowden conical thread holder dry box drybox
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 30
- Makes
- 0
- Views
- 432
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I have tried a few ways to make a revise Bowden setup for my Prusa MK3s.
This design requires only 220mm of 4mm OD PTFE tube to be bought, rest is printed.
(OD= outside diameter; ID=inside diameter)
I tried the 2mm ID but had difficulty pulling out the filament with the little ball of re-solidified filament so I went to 3mm id and now its perfect. I prefer the clear PTFE so you can spot any problems.
I still use the 2mm ID for my dry boxes, to keep the air out and also the ball then stops the filament going back too far.
The ptfe-screw-prusa is split in to two parts for ease of printing, just align them by putting PTFE tube in and glue them together with super glue.
I have also added the connector and the cap, incase you want to modify your existing dry boxes to this system.
See my other models, I am working on a DAISO 5.5l dry box project that goes with this design perfectly.