1 / 2
Car Boot Umbrella Hook
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A nifty storage hook to hold two umbrellas or fishing rods or anything long.
- Rating
- 0 / 5
- Likes
- 45
- Downloads
- 110
- Makes
- 0
- Views
- 2,200
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- GNU General Public License v3.0
Saw hooks on Aliexpress that go on the carpet section of your boot lid to hold umbrellas, etc. Thought I'd make them in an afternoon instead.
Assembly
Materials Needed:2x Umbrella_Holder (PETG/ABS/ASA)
2x M4 heat insert
2x M4x15 SHCS
Printing Instructions:
- Orient parts as shown in pictures.
- Print all parts with 0.2mm layer height, >10% gyroid infill.
Assembly Steps:
1. Take off the boot lid carpet and make two holes for the hooks.
2. Insert the heat inserts into the holes of each part.
3. Place the hook on the outside face of the carpet and use the M4x15 screw with a wide washer to fasten the hook.</code></pre>