Magnetic Logitech C270 corner mount for Prusa enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mounts to 45° surface in left or right front corner of a Prusa enclosure with two or three 8x3mm magnets
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 57
- Makes
- 2
- Views
- 427
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I designed this mount to be able to mount a Logitech C270 with 8x3mm magnets to the 45° surface of the left or right front corner of a Prusa enclosure. Alternative designs for printing without supports (V2) and another for ease of magnet removal or option of screw mounting (V3) in an alternative scenario.
* Two or three 8x3 magnets are press fit into the model, no glue should be required. Two magnets were adequate for me, but I have left the 3rd hole in the middle and therefore using is optional. This will likely depend on the strength of your magnets.
* A M3 x 12 screw can be used without a nut or longer with a nut. The tolerances enable the screw to cut a thread not requiring a nut.
To remove the Logitech C270 webcam from the original mount:
- remove the rubber caps from both sides, I used a pointed tweezers
- remove the cross head screw
- push the plastic pin out from the side the screw was removed, with same cross head screwdriver and long nose pliers - keep the plastic pin and rubber caps in case you want to reverse.
The printing material should ideally be slightly heat resistant to withstand enclosure temperatures - maybe PETG or ABS.