1 / 14
Portable Bass Shelf Speaker w/ Bluetooth (Tang Band + Dayton) — image 1
1 / 14

Portable Bass Shelf Speaker w/ Bluetooth (Tang Band + Dayton)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An "extended bass shelf" reflex design for use between 30Hz-18kHz. Tang Band W5-1138SMF / Dayton Audio DMA80-8.

Rating
0 / 5
Likes
126
Downloads
446
Makes
0
Views
3,623
Reviews
0

Updated at source:

Model information

Category
Audio
License
Creative Commons — Attribution — Noncommercial — Share Alike

Version 2.0 files available!
Key differences:

  • M3 mounting points for a more sleek printed handle at the top of the speaker

  • Barrel jack for power and mounting points for a battery holder at the back

  • JAB4 now mounts to the access panel for easier wiring

  • Woofer is fastened using heat inserts from the inside: Sub grill started to warp when using it to secure the woofer to it.

  • Use of countersunk screws

  • Improved internal cable routing


Bluetooth Backpack Speaker

I remodeled the entire enclosure from HexiBase and added a small extension at the front to allow the speaker grills to sit flush with the port. I also added an access panel and a small control panel with potentiometers, a on-off switch and a connector to program the DSP.

It is designed to work with a Wondom/Sure JAB4 4x30W DSP amplifier but can be fitted with different amplifiers.

Additionally a Parkside Battery can be mounted to the back.

There are two test models for you to make sure the tolerances fit your printer.

I printed mine with 4 outer walls and 30% infill, which consumed about 2.5kg of PETG in total.

For the assembly you will need a whole lot of M3 heat inserts and M3 screws (and some M4 ones to secure the woofer). I'm using heat inserts with a length of 5.7 and a diameter of 4.5mm. The holes for those are 6mm deep and 4mm wide.

I used a laser to cut the gaskets for the woofer and access panel out of 1mm thick self-adhesive foam board.

Note: For this speaker to sound properly, you'll have to edit the settings of the DSP. You are going to need a in-circuit programmer for that (i.e. Wondom ICP1).

I strongly recommend that you watch HexiBase's video first:

Tags