DRAPED ELEGANCE | Table Lamp

DRAPED ELEGANCE | Table Lamp

Enhance your space with our captivating table lamp shade that mirrors the natural charm of a draped fabric. This shade bathes your surroundings in gentle, warm light, creating an inviting atmosphere that effortlessly combines elegance with an organic touch.

It rests on a sleek tripod, designed for either E14 or E26 & E27 bulb sockets.

It also comes in wall light version at the link here.

You can get the power cords from Amazon here:
For Europe:
E27 cord:  https://amzn.to/3OVrZjK
E14 cord:  https://amzn.to/3TchBqs

For the US:
E26/E27 cord:  https://amzn.to/3V5VYJB

This lamp shade was designed to be printed fast, in a couple of hours in vase mode.

There are 2 versions of the lamp:
- the original one
- and a smaller version that can fit on PRUSA printers with 210 x 120 x 220mm printing volume.

Also, each shade comes in 2 versions:
- a smooth surface version (the original)
- and a textured version with little bumps all over to make it look more like paper/fabric, which helps hiding little printing defects.
 

SHADE (Large) | Ø 230 x H 225 mm | Printing: 2h ~ 3h (vase mode)
SHADE (For Prusa) | Ø 208 x H 218 mm | Printing: 2h ~ 3h (vase mode)

E14 BASE (Large) | W 200mm x L 175mm x H 107 mm | Printing: 2h ~ 3h
E14 BASE (for Prusa) | W 180mm x L 157mm x H 107 mm | Printing: 2h ~ 3h

E26/E27 BASE (Large) | W 200mm x L 175mm x H 107 mm | Printing: 2h ~ 3h
E26/E27 BASE (for Prusa) | W 180mm x L 157mm x H 107 mm | Printing: 2h ~ 3h

3D PRINTING SETTINGS

SHADE: 
The shade must be printed with bottom and top faces "open". 
You can either use the "spiralize" function to print in "vase mode" with 1 wall perimeter only (fine for the smooth shade version). 
Line width: 0.8mm to 1mm (even with a 0.4mm nozzle, you can push it to 1mm easily)

If you want 2 lines in your walls (recommended for the textured shade), do not activate "spiralize", but instead use the following settings: 
Resolution: 0.2 to 0.3mm / layer or less 
Wall Line Count: 2 
Infill: None 
Top layers: 0 (to get rid of the top face) 
Bottom layers: 0 (to get rid of the bottom face) 
Build adhesion type: 6 to 8mm brim 
Supports: None

BASE: 
The base must be printed upside-down, so with the feet pointing up, and the round opening for the E14 socket on the printing bed. 
Resolution: 0.2 to 0.3mm / layer or less 
Wall Line Count: 2 
Infill: 15 to 20% gyroid 
Build adhesion type: 6 to 8mm brim 
Supports: None