Universal Adjustable Cell Phone WebCam VESA 100 Mount for DroidCam

7/13/2022 - v1.0 - Finally! The initial release. I'm done with the holders that hang on the bezel on my monitor precariously. When I pound the desk after losing the umpteenth match of [insert your favorite FPS game here] I need it to withstand the jostles, bumps, and unfiltered "YEAH RIGHT!" screams.

So, here it is. Fully adjustable to tilt in any direction. I designed it on a VESA 100 monitor, which is the most common size unless you're really sized down. My monitors are 27 inches. I figured I'd give it some height that could take on a 32" (or perhaps taller?) monitor.

My monitor is curved, but, I made sure it would "fit" on a flat-back monitor as well.

The phone-pincher is made of TPU so I can slide all kinds of phones into it. Case? No problem. This phone-pincher piece slides into a little slot at the top of the tilt-ball, so, REMIX YOUR HEART OUT and feel free to make a different one for a different circumstance. You want your 13 inch iPad above your monitor? Frick'n do it (but make sure its sturdy, haha)

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

.20

Infill:

Filament: COEX PLA & TPU Various

Notes:

Category: Computer